X-T10 Transmitter
X-T10 Transmitter
The tension transducer converts millivolt output signal of tension sensors into analog signal or digital signal in real time, and provide closed loop control for PLC, servo drive, IPC and other control systems. It adopts guide rail type installation. With built-in digital display, tension is displayed in real time. It is convenient for rapid tension reset and alarm output with switching I/O nodes
Category
X-T10 Transmitter
Features
●Display digital: 6-digit
●Switching input/output: CH-1/CH-2
●Reset: panel, switch input, clear command;
●Analog transmission: 0-10V，±10V，4-20mA
●Digital output: RS232，RS485
●Protocol: MODBUS-RTU,TC-ASCII
●Analog transmission range: -100% – +100%FS
●Power reverse polarity protection.
Description
The tension transducer converts millivolt output signal of tension sensors into analog signal or digital signal in real time, and provide closed loop control for PLC, servo drive, IPC and other control systems. The transducer adopts guide rail type installation. With built-in digital display, tension can be displayed in real time. It is convenient for rapid tension reset and alarm output with switching input and output nodes.
Technical Parameter
| Power supply | DC24V/5W | AD resolution | 24 bit |
| Sensor’s supply voltage | 5VDC,200mA | Sampling rate | 480-1920 Times/Sec. |
| Input signal range | 0-20mV | Transmitting speed | =Sampling rate |
| Non-linearity | 0.01%F.S. | Switch output type & capacity | NPN/PNP,500mA |
| Accuracy | 0.5%F.S. | Switch input type | NPN |
Dimensions
Selection
| Model | Input signal | Accurancy | Power supply | Signal output | Special requirements |
| XJC-T100F | M:mV | B:0.05%
D:0.1%-0.5% |
D:24VDC | R2: RS232,
R4: RS485, V:0-10V OR ±10V A:4-20mA |
Y/N |
